Exchange Server Forums

Event ID 7002 and 7004

Users viewing this topic: none

Logged in as: Guest

Printable Version

All Forums >> [Microsoft Exchange 2003] >> General >> Event ID 7002 and 7004

Page: [1]

Message

<< Older Topic Newer Topic >>

Event ID 7002 and 7004 - 28.Jun.2005 12:35:00 PM

jmccoy1959

Posts: 32
Joined: 31.May2005
From: Utah
Status: offline

I am getting these Event ID's in the log, event ID 7004 reads: This is an SMTP protocol error log for virtual server error for ID 1,connection #1070. The remote host "63.238.11.103", responded to the SMTP command xexch50 2352 2 This will probably cause the connection to fail.

ID 7002 reads: This is an SMTP protocol warning log for virtual server ID 1, connection #1060 The remote host 65.168.34.131, responded to the SMTP command "rcpt" with "451 Requested action aborted:local error in processing". The full command sent was RCPT To:<email address>" This may cause the connection to fail.

According to MS they say to upgrade the drivers, has anyone seen this before and do you agree with MS? Or am I looking at a different problem?

Thanks

Post #: 1

Featured Links*

RE: Event ID 7002 and 7004 - 29.Jun.2005 3:38:00 AM

mark@mvps.org

Posts: 6811
Joined: 9.Jun.2004
From: Philadelphia PA
Status: offline

What drivers are they telling you to upgrade, and is that all they told you?

(in reply to jmccoy1959)

Post #: 2

RE: Event ID 7002 and 7004 - 29.Jun.2005 11:16:00 AM

jmccoy1959

Posts: 32
Joined: 31.May2005
From: Utah
Status: offline

Here is what MS says according their support:

Possible causes for this event include faulty network card drivers and network cards that are configured incorrectly.

Note You will see Event 7004 only if you turn up diagnostic logging on the MSExchangeTransport event source to Medium or higher.

User Action
To resolve this error, try one or more of the following:

Make sure that the latest network card drivers and firmware are installed.

Run any network diagnostics software that was supplied with the network cards to verify that the network cards are functioning correctly.

If the network cards are configured to automatically detect the speed of the connected network, change the configuration to use a specific speed setting.

(in reply to jmccoy1959)

Post #: 3

RE: Event ID 7002 and 7004 - 5.Jan.2007 10:48:50 AM

dongoran

Posts: 31
Joined: 5.Jan.2007
Status: offline

Hy everyone. I have sam problem, about Evnet id 7002. My opinion about this, and what i done. I chnange in Logging diagnostic option in properties of System Manager in MSExchange transport , option SMTP protocol on NONE. Before that it check box was on Maximum. In next few days I will see the results of my work.

Saluta tutti.

(in reply to jmccoy1959)

Post #: 4