Exchange Server Forums

Receive Connector authentication

Users viewing this topic: none

Logged in as: Guest

Printable Version

All Forums >> [Microsoft Exchange 2007] >> Message Routing >> Receive Connector authentication

Page: [1]

Message

<< Older Topic Newer Topic >>

Receive Connector authentication - 25.Jun.2010 2:52:59 AM

listers@live.com

Posts: 138
Joined: 13.Jun.2009
Status: offline

Please advice.
When creating a receive connect to accept messages from Mail Marshal smarthost, how must you configure authentication and permissions.

Thanks

Post #: 1

Featured Links*

RE: Receive Connector authentication - 28.Jun.2010 6:46:44 AM

Exchange_Geek

Posts: 1287
Joined: 31.Dec.2006
Status: offline

Read the following link
http://www.m86security.com/kb/article.aspx?id=11868

Regards,
Exchange_Geek

(in reply to listers@live.com)

Post #: 2

RE: Receive Connector authentication - 28.Jun.2010 8:12:42 AM

listers@live.com

Posts: 138
Joined: 13.Jun.2009
Status: offline

Thanks will read through and feedback.

(in reply to Exchange_Geek)

Post #: 3

RE: Receive Connector authentication - 29.Jun.2010 4:38:23 PM

listers@live.com

Posts: 138
Joined: 13.Jun.2009
Status: offline

I followed the same procedure. I was getting error "Server refused mail at MAIL FROM - 530 5.7.1 Client was not authenticated" I got it right after using the public IP on the receive connector.

Thanks again for the link.

(in reply to listers@live.com)

Post #: 4

RE: Receive Connector authentication - 30.Jun.2010 7:36:29 AM

Exchange_Geek

Posts: 1287
Joined: 31.Dec.2006
Status: offline

1) Which permission group has been added under the new receive connector properties.
2) MailMarshal would give you an ip range to work with - right OR only ip address is shared with you?

Regards,
Exchange_Geek

(in reply to listers@live.com)

Post #: 5

RE: Receive Connector authentication - 30.Jun.2010 9:39:08 AM