Failed to failover to another routing connector (Full Version)

All Forums >> [Microsoft Exchange 2003] >> Message Routing



Message


xchange78 -> Failed to failover to another routing connector (18.Sep.2007 3:09:57 PM)

Hi all,

I have set up 2 connector A and B with routing cost of 10 and 11. The configuration is perfect and correct. At some point when remote bridgehead Server A1 is down (normally using connector A), the local bridhead server failed to faileover using Connector B to send email to another Server A2. (note : Server A1 and Server A2 are in same location) .

I planning to do it same exercise where I will shutdown A1 and see if local bridgehead server successfully or not use connector B to send email to Server A2. To what point should I investigate this issue. Now I setting the connector from 10 and 11 to use 8 and 9. Any advice is welcome.




Page: [1]