• Twitter
  • FaceBook

Exchange Server Forums

Forums | Register | Login | My Profile | Inbox | RSS RSS icon | My Subscription | My Forums | Address Book | Member List | Search | FAQ | Ticket List | Log Out

Exchange 2007 Deployment

Users viewing this topic: none

Logged in as: Guest
  Printable Version
All Forums >> [Microsoft Exchange 2007] >> Installation >> Exchange 2007 Deployment Page: [1]
Message << Older Topic   Newer Topic >>
Exchange 2007 Deployment - 7.May2010 12:33:42 PM   


Posts: 1
Joined: 7.May2010
Status: offline
Hello All,
I am new in this forum but got lots of solutions from this forum earlier searching on net. I need your help to deploy a little complex environment. I want to deploy exchange server 2007 where DC and DR sites are available. DC and DR is connected with high speed fiber where latency is very low. I have 2 High end servers (32GB RAM, 3TB Storage, Dell power edge R9000), two low end servers (300GB storage) and there are 1 AD and 3 ADCs in DC and one ADC in DR. I have purchased 1 license for Exchange server 2007 Ent. and 2 Exchange Server 2007 Std versions. I have one server with ISA server 2006 also. I need to have the environment with fail over replication (SCR/CCR or something else). Please suggest me the design and your valuable suggestions. Thanks.


< Message edited by shamsarafat -- 7.May2010 12:38:50 PM >


Post #: 1
RE: Exchange 2007 Deployment - 13.May2010 11:18:14 PM   


Posts: 720
Joined: 9.Feb.2003
From: sydney
Status: offline
The only difference between Standard and Enterprise version of Exchange is CCR and limitation of Storage Groups.

I would put the Enterprise on your primary site as mailbox server role and then have 1 of the standard running as CAS/HT. Then on the DR site, I would put the other Standard Exchange server with CAS/HT/mailbox server role.

Run SCR between primary mailbox server and DR mailbox server.This will allow you to have a DR situation if the primary site goes down i.e. CAS/HT server have hardware issue then all incoming emails will go through the DR CAS/HT/mailbox server and this will be the same as the mailbox server on your primary site.

As for SCR, it will be a manual failover so check out the post on this site.


(in reply to shamsarafat)
Post #: 2

Page:   [1] << Older Topic    Newer Topic >>
All Forums >> [Microsoft Exchange 2007] >> Installation >> Exchange 2007 Deployment Page: [1]
Jump to:

New Messages No New Messages
Hot Topic w/ New Messages Hot Topic w/o New Messages
Locked w/ New Messages Locked w/o New Messages
 Post New Thread
 Reply to Message
 Post New Poll
 Submit Vote
 Delete My Own Post
 Delete My Own Thread
 Rate Posts

Follow TechGenix on Twitter