Receive Connector authentication (Full Version)

All Forums >> [Microsoft Exchange 2007] >> Message Routing



Message


listers@live.com -> Receive Connector authentication (25.Jun.2010 2:52:59 AM)

Please advice.
When creating a receive connect to accept messages from Mail Marshal smarthost, how must you configure authentication and permissions.

Thanks




Exchange_Geek -> RE: Receive Connector authentication (28.Jun.2010 6:46:44 AM)

 
Read the following link
http://www.m86security.com/kb/article.aspx?id=11868

Regards,
Exchange_Geek




listers@live.com -> RE: Receive Connector authentication (28.Jun.2010 8:12:42 AM)

Thanks will read through and feedback.




listers@live.com -> RE: Receive Connector authentication (29.Jun.2010 4:38:23 PM)

I followed the same procedure. I was getting error "Server refused mail at MAIL FROM - 530 5.7.1 Client was not authenticated" I got it right after using the public IP on the receive connector.

Thanks again for the link.




Exchange_Geek -> RE: Receive Connector authentication (30.Jun.2010 7:36:29 AM)

1) Which permission group has been added under the new receive connector properties.
2) MailMarshal would give you an ip range to work with - right OR only ip address is shared with you?

Regards,
Exchange_Geek




listers@live.com -> RE: Receive Connector authentication (30.Jun.2010 9:39:08 AM)

The Anonymous Users are ticked. The problem was the MM IP i used. I changed it an mails started coming through.




Exchange_Geek -> RE: Receive Connector authentication (30.Jun.2010 9:40:36 AM)

Awesome :)

Regards,
Exchange_Geek




Page: [1]