Exchange Server Forums

Add 2nt trusted domain to exchange 2010 server

Users viewing this topic: none

Logged in as: Guest

Printable Version

All Forums >> [Microsoft Exchange 2010] >> Installation >> Add 2nt trusted domain to exchange 2010 server

Page: [1]

Message

<< Older Topic Newer Topic >>

Add 2nt trusted domain to exchange 2010 server - 18.Jan.2011 11:06:11 PM

Amore514

Posts: 1
Joined: 18.Jan.2011
Status: offline

I need some advice with an exchange 2010 setup.
I have 2 companies and 2 domains one for each company, and we have a trust for the domains. I installed a single exchange 2010 in domain A and I have setup all the users in domain A with email box�s, I want to now add Domain B and add these users to the same exchange server the exchange server does not see the users in domain B.

Im trying to add a 2nt domain forest but im getting the error below, or maybe Im going about this the wrong way?

Connecting to domain B.
The attempt to connect using HTTPS protocol "Kerberos" failed: Connecting to remote server failed with the following error message : WinRM cannot process the request. The following error occured while using Kerberos authentication: The network path was not found.
Possible causes are:
-The user name or password specified are invalid.
-Kerberos is used when no authentication method and no user name are specified.
-Kerberos accepts domain user names, but not local user names.
-The Service Principal Name (SPN) for the remote computer name and port does not exist.
-The client and remote computers are in different domains and there is no trust between the two domains.
After checking for the above issues, try the following:
-Check the Event Viewer for events related to authentication.
-Change the authentication method; add the destination computer to the WinRM TrustedHosts configuration setting or use HTTPS transport.
Note that computers in the TrustedHosts list might not be authenticated.
-For more information about WinRM configuration, run the following command: winrm help config. For more information, see the about_Remote_Troubleshooting Help topic.
The attempt to connect using HTTPS protocol "Basic" failed: Connecting to remote server failed with the following error message : The WinRM client cannot process the request. Unencrypted traffic is currently disabled in the client configuration. Change the client configuration and try the request again. For more information, see the about_Remote_Troubleshooting Help topic.

Post #: 1

Featured Links*

RE: Add 2nt trusted domain to exchange 2010 server - 21.Jan.2011 7:39:05 AM

Marc.dekeyser

Posts: 225
Joined: 19.Apr.2010
Status: offline

It sounds like you're trying to use one exchange organisation for two different forests? If so you'd probably be better of looking at how to setup a hosting solution on your exchange or migrating domain B to Forest A.

_____________________________

* No rights or priviliges can be taken from my posts.
* Always make a backup!
* http://kb.geminon.be

(in reply to Amore514)

Post #: 2